NASA’s Mars lander InSight will reach the top of the mole, After nearly a year of trying to dig into the surface of Mars, the thermal investigation of NASA InSight entrants will get a boost.

The mission team plans to order the scoop of the InSight robot arm to push the mole, mini ram to hit the hammer up to 5 meters.

They hope the pressure on the top of the mole, also known as the back cover, will prevent it from freeing its hole on Mars, as it did twice in the last few months after it almost buried itself. NASA’s Mars lander InSight will reach the top of the mole.

As part of a device called HP3 (Heat Flow and Physical Properties Pack), the mall is a 40 centimeter spike equipped with an internal impact mechanism. When digging to the ground, a ribbon must be pulled, which extends from the spacecraft.

Temperature sensors are installed along the tetras to measure heat from the depths of the planet and reveal important scientific details about the formation of Mars and all rocky planets, including Earth. HP3 is provided to NASA by the German Aerospace Center (DLR). NASA’s Mars lander InSight will reach the top of the mole.

Since then, the InSight team has found that the land here is different from those in other parts of Mars. The view and ends in an area with a solid burrito or a layer of cement soil.

Malls require friction from the floor to move down. Without them, withdrawing from suicide only made him jump into place. Ironically, a loose bottom, not two hairs, causes this friction when it falls around the mole. Last summer, the InSight team began using a robotic arm spoon to push the side of the mole. This technique is called “pinching” and adding enough friction to make excavation easier without contact with the fragile scientific tether associated with the back cover of the mole. NASA’s Mars lander InSight will reach the top of the mole.

It takes some effort to refine the back cover, just like when installing. The InSight arm maneuvers in late February and early March so the team can review what happens when the mole runs out.

Meanwhile, the team is also considering using a spoon to pump more soil into the holes formed around the mole.

This can cause more pressure and friction, which can eventually break it. Whether you continue this route or not depends on how deep the traveler can travel after pressing the back cover.